Table of Contents
Advertisement
5.5.4 M
C
ULTIPLE
Dana is on a business trip and has RMN Conditions set to notify her when she
gets either a fax or a TAD message. But she's found that she's receiving
almost exclusively nuisance faxes like price lists and advertisements, so she
wants to change the RMN Conditions to notify her only of TAD messages.
Also, she's arrived at a new city, so she wants to change the RMN Phone
Number. She writes down the Security Access Code she must enter to get into
the programming mode ([6] [0] [0] [5]), the number of the RMN
Conditions function ([8]), the TAD-only setting ([1]), and the entry-ending
key ([*]); the number of the RMN Phone Number function ([7]), the new
phone number (1 212 555 1192), and another entry-ending key ([*]); and
finally the save-and-exit key ([*]). She picks up the receiver of her hotel
phone, dials the ASD-4's number, and waits until it answers. Then, between
"phantom rings," she enters the Security Access Code:
She waits one or two seconds to make sure that the "phantom rings" stop. If
they don't, she enters the code again after the next ring. If they do, she
carefully but quickly presses this key sequence:
, P
HANGES
ROGRAMMED
[6] [0] [0] [5]
[8] [1] [*]
[7] [1] [2] [1] [2] [5] [5] [5] [1] [1] [9] [2] [*]
[*]
CHAPTER 5: Programming the ASD-4
R
EMOTELY
(should hear three beeps)
(three more beeps)
(call is transferred to TAD port;
can hang up right away or check
for messages)
63
Advertisement
Table of Contents
