Table of Contents
Advertisement
ASD-4
If he has done this correctly, he will hear three short beeps, after which he
must press
one more time to save his changes. Once he does so, his call will be
transferred to the TAD port, so he can either hang up immediately or check
for any additional messages first.
5.5.3 M
C
ULTIPLE
A friend who didn't need it any more has given Carl an ASD-4. However, the
friend neglected to give Carl any information about the ASD-4's current
settings. So Carl has read the ASD-4's manual and decided he's satisfied with
most of the factory settings, except that he wants Open Line Notification ON
and he wants automatic transfers to go to the MODEM port. He writes down
the keys he must press to get into the programming mode ([#] [*]), the
number of the Reset to Factory Settings function ([9][9][9]), and the entry-
ending key ([*]); the feature-ON key ([1]), the number of the OLN feature
([1]), and another entry-ending key ([*]); the MODEM-port key ([1]), the
number of the Automatic Transfer Port Selection feature ([1][2]), and a
third entry-ending key ([*]); and finally the save-and-exit key ([*]). Then he
picks up the receiver of the phone connected to his ASD-4's PHONE port and
carefully but quickly presses this key sequence:
62
, P
HANGES
ROGRAMMED
[#] [*] [9] [9] [9] [*]
[1] [1] [*]
[1] [1] [2] [*]
[*]
[*]
L
OCALLY
(should hear three beeps)
(three more beeps)
(three more beeps)
(dial tone)
Advertisement
Table of Contents
