Table of Contents
Advertisement
ASD-4
5.3 The Features (ON/OFF Options) in Detail
In the previous section, Table 5-1 lists the features: the capabilities of the
ASD-4 that can be switched between two values. These features are numbered
[0] through [1][2]. In this section you find a description of each feature and
instructions for switching each feature.
To turn a feature ON (or, for features [1][1] and [1][2], to switch to the
MODEM port): Access the programming mode, then press [1], followed by
the desired feature number, followed by [*] to end the program entry. To
turn a feature OFF (or, for features [1][1] and [1][2], to switch to the FAX
port): Access the programming mode, then press [0], followed by the desired
feature number, followed by [*] to end the program entry.
When you are finished with your changes: If you've made a mistake or
changed your mind and don't want to save the changes, press [#] [*] to exit
the programming mode without saving. (The ASD-4 will continue using the
most recently saved settings.) If you do want to save the changes, press the [*]
key to save and exit.
Example: To turn Pulse Transfer ON, enter the programming mode and
press [1] [4] [*]. Press [*] again to save the changes and exit the programming
mode. To turn Pulse Transfer OFF, enter the programming mode and press
[0] [4] [*]. Press [*] again to save the changes and exit the programming
mode.
5.3.1 F
[0]: A
EATURE
This feature ensures that the ASD-4 receives all fax and modem transmissions
when it is unattended (if an answering machine is not connected to the ASD-
4). The feature is designed mainly to accommodate auto-dial faxes that do not
produce CNG tones.
During unattended hours, if your phones aren't answered by the sixth ring
(or the number of Rings Available to the TAD and PHONE Ports—see
Section 5.4.8), the ASD-4 automatically reduces the number of rings available
to the TAD and PHONE ports to two. The next time a call is answered and
routed to the TAD and PHONE ports, the ASD-4 will only ring the TAD and
PHONE ports two times and then route the call to the FAX or MODEM port
(depending on the setting of feature number [1][2], Automatic Transfer Port
Selection).
If you don't want the Automatic Ring Reduction feature to reduce the ring
count on the TAD and PHONE ports, you can turn the feature OFF. The
feature is factory-preset ON, [1] [0] [*].
42
R
R
UTOMATIC
ING
EDUCTION
Advertisement
Table of Contents
