Appendix C: Remote Programming Card - Black Box ASD-4 Manual

Automatic sharing device

Hide thumbs

Table Of Contents

Table of Contents

Remote Programming Card

If you think you might need to program the ASD-4 or retrieve TAD messages

remotely, make a copy of this page and cut out the card below (don't separate

its two sides). Fold and tape or glue the two sides together.

If you leave the card unlaminated, you can write directly on it, then make a

new card later if you change your Security Access Code. If you laminate the

card, however, you can write on the lamination with marker and cover the

writing with transparent tape to keep it from smearing; this way, when you

need to change your Security Access Code, you can just remove the tape, wipe

off the marker, and start over.

Remote Progranming

Card for the ASD-4

When you want to program the ASD-

4, call its phone number from a

touch-tone phone. After the ASD-4

answers, enter your Security Access

Code between ring signals.

Your Security Access Code is:

___

After you enter the code, you can

make programming changes. You

must press the [*] key after each

program entry. Press the [#] key to

discard changes you've made up to

that point. After your final program

entry, press the [*] key twice to save

and exit.