Function [3][2]: Fax Port's Distinctive Ring Assignment; Function [3][3]: Modem Port's Distinctive Ring Assignment - Black Box ASD-4 Manual

ASD-4
5.4.5 F [3][2]: FAX P
UNCTION
This function defines the type of Distinctive Ring Service (DRS) ring pattern
to be routed to the FAX port. (See Section 4.3.)
You can't assign more than one distinctive ring pattern to each port. If you
leave a particular ring pattern unassigned, the ASD-4 routes calls with that
pattern to the TAD and PHONE ports. The FAX Port's Distinctive Ring
Assignment is factory-preset to a two-burst ring pattern, [3][2] [2] [*].
Example: To change the FAX Port's Distinctive Ring Assignment to a three-
burst ring, enter the programming mode and press the following on your
tone phone:
[3][2] Change FAX Port's Distinctive Ring Assignment to
[3] The desired ring assignment
[*] End programming sequence (3 beeps indicate correct entry)
.
. (Optional entries for additional changes)
.
[*] Save changes and exit programming
Do not assign the same ring pattern to more than one port. If a ring
pattern is assigned to more than one port, the ASD-4 routes the call to
only one of the assigned ports.
5.4.6 F [3][3]: MODEM P
UNCTION
This function defines the type of Distinctive Ring Service (DRS) ring pattern
(ring bursts) to be routed to the FAX port. (See Section 4.3.)
You can't assign more than one distinctive ring pattern to each port. If you
leave a particular ring pattern unassigned, the ASD-4 routes calls with that
pattern to the TAD and PHONE ports. The MODEM Port's Distinctive Ring
Assignment is factory-preset to a three-burst ring pattern, [3][3] [3] [*].
Example: To turn OFF the MODEM Port's Distinctive Ring Assignment,
enter the programming mode and press the following on your tone phone:
54
' D
ORT S ISTINCTIVE
NOTE
' D
ORT S ISTINCTIVE
R A
ING SSIGNMENT
R A
ING SSIGNMENT