Installing The Asd-4 On A Single Line With A Single Phone - Black Box ASD-4 Manual

ASD-4

3.3 Installing the ASD-4 on a Single Line with a Single Phone

Figure 3-1, below, shows a single line/single phone arrangement before
installation of the ASD-4. If you have this type of arrangement, you can install
the ASD-4 yourself using the instructions provided in this section.
Figure 3-1. Single-line/single-phone arrangement before ASD-4.
Figure 3-2, on the next page, shows the ASD-4 installed for a single-
line/single-phone arrangement. To perform this installation, follow these
steps:
1. Unplug the telephone cable from the wall jack.
2. Plug one end of the telephone cable provided with the ASD-4 into the
LINE-IN port on the back of the ASD-4. Plug the other end of the cable
into the wall jack where the phone was connected.
3. Plug the small end of the AC power cord provided with the ASD-4 into
the power input jack labeled "12VAC" on the back of the ASD-4. Plug the
AC adapter into a standard outlet.
The ASD-4 begins a self-check as soon as you plug it in. The green LED
labeled ON flashes during this test. When the ASD-4 completes its self-check,
the ON LED should stop flashing and remain steadily illuminated. (If the
LED continues to flash, and any peripheral equipment you have already
connected to it is on hook, call for technical support.)
6