Disassembly Of The Fusing Unit - Konica Minolta Di1610 Service Manual

Look at the stop position of the Take-Up Roller from Clutch Gear side.
(6)

Disassembly of the Fusing Unit

NOTE
• The Fusing Unit is extremely hot immediately after the Power Switch has been turned
OFF. Allow a sufficient time to let it cool down before starting the procedure to prevent
burn.
1. Remove the Fusing Unit.
☞ D-8
Upper Fusing
Roller section
Lower Fusing
Roller section
After setting replaced Paper Take-Up Clutch Gear
(Torque Limiter) to the shaft, Rotate the Paper Take-
Up Clutch Gear by hand (Need to be released Sole-
noid Flapper).
4136D060AA
1. When the Roller is leant to clockwise, move the
coupling Gear to A direction.
4136D046AA
2. When the Roller is leant to counter clockwise,
move the coupling Gear to B direction.
4136D045AA
2. Remove the two screws, and then the Fusing Unit
is divided into the Upper Fusing Roller section
and Lower Fusing Roller section.
4136D021AA
D-26