Table of Contents
Advertisement
Chapter 12. Installation Procedures
This chapter describes how to install the 3708.
Notes:
1. Before installing the 3708 you must complete initial setup of the 3708. Refer to
IBM 3708 Network Conversion Unit Setup (shipped with the 3708), complete the
initial setup procedures, and then, refer to this book for information on how to
configure and install the 3708 into the network.
2. You should complete the Address Registration Form that is shipped with the
3708.
3. Before installing the 3708, it is recommended that you acquire any known
microcode fixes (MCFs) for your level of microcode. This can be accomplished
by calling the service number (see "Calling for Service" on page 6-3) and
requesting that all existing MCFs be installed.
Installation consists of the following steps:
• Step 1. Testing the 3708
• Step 2. Setting Up the Control Terminal
• Step 3. Logging onto the Control Terminal
• Step 4. Entering the Configuration Data
• Step 5. Activating the Configuration
• Step 6. Ending the Control Terminal Session
• Step 7. Connecting the Cables.
Chapter 12. Installation Procedures
12-1
Advertisement
Table of Contents
