What To Do Next - IBM 3708 Planning And Installation

Note: If a device is defined as a display with printer (Device Class
=
4), the
carriage return delay value applies to the printer, not to the display.
[000 - 255]
Type the number of DEL (X '7F') characters that the 3708 is to transmit to the
device after sending a carriage return. This allows time for the printer element to
move back to the left margin.
Maximum Platen Length
[000 - 255]
Type the platen length of the printer in characters. This value is the default for the
maximum print position, which is the maximum number of characters that fit on one
line of the printer.
Note: If the host transmits a set horizontal format (SHF) command during an
LU_l SCS printout and specifies a page width greater than the maximum platen
length, the 3708 rejects the data from the host with a sense code of X' 1005'.
What To Do Next
The next screen you should go to depends on the type of device that you are
configuring and what you want to do with it.
• If you are using protocol enveloping or dynamic mode, continue with the
following section, "Protocol Enveloping Definition for an End-User Device
(Screen CI23.4)." Then, if the device is a printer or a keyboard display with
printer, follow the instructions under "Defining the Printer Authorization
Matrix" on page 13-41.
• If you are using protocol conversion mode and the device is a printer or a
keyboard display with printer, go to "Defining the Printer Authorization
Matrix" on page 13-41.
• If you are using protocol conversion mode only and the device is not a printer
or a keyboard display with printer, go back to the beginning of this section,
"Defining a Port for an End-User Device" on page 13-15.
Chapter 13. Configuration Procedures
13-35