How To Change The Target Vehicle Speed; Using An Accelerator Pedal; Using The Brake Pedal; Cruise Control System - Suzuki Wagon R Instruction Manual

000.book 31 pages Friday, July 28, 2017 2:30 PM

■ Cruise control system

While using the machine, be
careful with this
Even cars equipped with dual sensor brake support
will not automatically accelerate or decelerate
according to the speed of the vehicle in front. Please
do not use the cruise control system if you can not
travel at a constant speed safely.
→ page 4-47 (Dual Sensor Bus
LEXA PORT)
 Even if the following situation occurs
while driving at a constant speed, the
SET display will not go out and the
constant speed running will not be
canceled.
· When a forward collision warning
sounds. When stepping on the brake
pedal, constant speed running is
temporarily canceled.
· When dirt sensor on the windshield is
detected and the dual sensor brake
support is stopped. For safety, press
the cruise switch (1)
Please turn off the cruise control
display.
 Cruise when automatic brake of dual
sensor brake support is activated
The control display goes out and the
cruise control system is canceled.
Please verify the surrounding safety
and repeat the vehicle speed setting.
If you want to temporarily accelerate or decelerate
■ When you want to accelerate
Please step on the accelerator pedal. You
can accelerate it like normal running.
When you release your foot from the

accelerator pedal, it automatically
returns to the original constant
speed running.
When driving / cruise control system
■ When you want to decelerate
Please step on the brake pedal. The constant
speed traveling is canceled and the SET
display (5) goes out. (Standby state)
 When the vehicle speed is about 45 km
or more, the vehicle speed setting switch
When you press the RES + side of the
switch (3), the SET indicator lights up and
automatically returns to the original
constant speed running.
Even if shifting down in the manual
mode, when the gear position is 3 or
more, the constant speed running will
not be canceled, so the engine brake will
not work. Please decelerate by operating
brake pedal or vehicle speed setting
switch.

How to change the target vehicle speed

■ Using an accelerator pedal

Accelerate to the desired vehicle speed
and press the SET - side of the vehicle
speed setting switch (3).

■ Using the brake pedal

Decelerate to the desired vehicle speed and
press the SET - side of the vehicle speed
setting switch (3).
The SET indicator (5) turns off until
you step on the brake pedal and reset
it. (Standby state)
Caution
Advice
4-31
4