Suzuki Wagon R Instruction Manual page 252

000.book 61 pages Friday, July 28, 2017 2:30 PM
 In the following situations, the
high beam may not be automatically
switched to low beam.
· When you suddenly mistake an
oncoming car with a bad curve
· When another vehicle crosses the
front of the own vehicle
· When forward vehicles are seen and
hidden by continuous curves, median
strips, street trees, etc.
· When a vehicle ahead approaches
from a lane away from you
· When the vehicle in front is no-light
 High beam and low beam
The switching timing of the switch
may change.
· Brightness of the lamp of the forward
vehicle
· When the lamp of the forward vehicle is
lit only on one side
· Movement and direction of the vehicle
ahead
· When the vehicle in front is a
motorcycle
· State of road (gradient, curve, road
surface condition, etc.)
· Number of passengers and baggage
 Under the following circumstances, ambient
brightness may not be accurately detected, high
beams may cause pedestrians, preceding vehicles
or other inconveniences, and low beams may
continue. In such a case, manually high beam and
Please switch the low beam.
· When there is light that resembles a
head lamp, a taillight, etc.
· When the lamp of the forward vehicle is
no light
· When there is dirt or discoloration on
the lamp of the forward vehicle
· When the optical axis of the head lamp
of the oncoming vehicle is misaligned
· When the rapid change in brightness
continues
When traveling on a road with many
undulations and steps
· When traveling on a road with many
curves
When driving / Driving support function
· When there is something that reflects
light strongly like a sign or a mirror in
front of the vehicle
When the rear part of a vehicle ahead
such as a container strongly reflects light
· When the headlight of your car is
damaged or dirty
· When the subject vehicle is tilted due to
puncture, towing or the like
Other than the above, the laser radar and the
monocular camera may not be able to
recognize the vehicle in front and the light
source, and the high beam assist function
may not operate correctly.
→ page 4-40
(Laser radar and monocular camera)
 In the following cases, the high beam reed
Please manually switch between high beam
and low beam without using the strobe.
· When high beam and low beam frequently
change
· There is a problem with the use of the high
beam
· When you think that other drivers or
nearby pedestrians will be inconvenienced
 By fog lamps ahead of the vehicle,
The high beam may switch to low beam.
 The high beam may switch to low beam
or the low beam may continue due to street
light, lighting such as signal or
advertisement, reflective object such as
signs or signboards.
4
4-61