Display Example (In Case Of Energy Flow Indicator) - Suzuki Wagon R Instruction Manual

000.book 107 page Friday, July 28, 2017 2:30 PM
Switch to setting mode.
1
 Press and hold the display switching knob or info switch to switch to
odometer display.
→ page 3-100 (odometer)
 During odometer display, press and hold the knob or switch until it
switches to the setting mode display.
Select the display whose setting you want to switch.
2
Press the display changeover knob or info switch for a short time to switch the display.

Move to setting change display.
3
 Press and hold the display switching knob or info switch. The indoor buzzer beeps
and switches to ON setting display (1) in the figure below (display example).

Display example (in case of energy flow indicator)

(1)
(1) ON setting display (currently set) (2) OFF setting display (3) BACK display
Advice
As shown in (1) in the above figure, it
indicates that it is inside the setting
display on the left.
Switch the setting.
4

To change the setting, short press the display switching knob or info switch
and select ON or OFF. Then press and hold the knob or switch. When the
indoor buzzer beeps and "
the display returns to step 2.
 To go back to step 2 without setting change, select and press the knob or
switch until the indoor buzzer beeps until after selecting BACK display (3).
If you want to change the setting in succession, repeat steps 2-4.
5
To exit the setting mode, proceed to step 6.
Exit the setting mode. You can end with one of the following operations. Proceed to 6.
6

At the display in step 2, proceed to "6.
Continue to 6 Press and hold the display changeover knob or info switch till you go to 6
 Switch the engine
Start running
(2)
A B
" is displayed, the setting switches and
」After selecting it, switch to odometer display and proceed to 6.
Or
ACC
LOCK
（OFF）To
Before driving / meter
(3)
74P30530
Is displayed is the current setting
3
3-107