Vehicle Proximity Notification Device; Temporary Cancellation; Release Of System; Using The Vehicle Speed Setting Switch - Suzuki Wagon R Instruction Manual

000.book 32 pages Friday, July 28, 2017 2:30 PM
When driving / vehicle notification device

■ Using the vehicle speed setting switch

 When accelerating, set the vehicle
speed setting switch
Press and hold the RES + side of (3).
 When decelerating, set the vehicle
speed setting switch
Press and hold the SET - side of (3).
When the target vehicle speed is
reached, let go of the switch.
Advice
By pressing the switch for a short time, it
is possible to finely adjust the target
vehicle speed (about 1.6 km / h).
4
How to cancel the constant speed running

■ Temporary cancellation

When either one of the following operations is performed,
or when the vehicle is in one of these states, the SET
indicator (5) goes out and goes into the standby state.
 Press the cancel switch (2)
 Depress the brake pedal
 When the vehicle speed declines by more
than 20% or about 40 km / h or less from
the target vehicle speed, for example when
traveling on an uphill slope
 When shifting down in the manual mode
and the gear position becomes 2 or less
 In the case of ESP® equipped vehicles,
when the vehicle is about to slide sideways
(including ESP® operation)
 In the case of a vehicle equipped with a
dual sensor brake support, when a forward
collision warning brake or an automatic
brake is activated
When the vehicle speed is about 45 km / h
or more and the RES + side of the vehicle
speed setting switch (3) is pressed after
the situation at the time of temporary
release is resolved, the SET display lights
up, It returns to constant speed running.
4-32

■ Release of system

 Press the cruise switch (1) to turn off the
cruise control display (4).
 When the engine warning light in the meter
turns on or blinks, the cruise controller
The display will turn off and the system will be
released.
→ Page 3-77 (engine warning light)
Advice
When the cruise control display
turns off and the system is canceled,
the set target vehicle speed is reset.
車両接近通報装置

Vehicle proximity notification device

Type-specific equipment
When making a creep with a motor or the like, a
beep sounds to inform the surrounding people of
the approach of the vehicle.
When the surrounding noise is large, or when it is
heavy rain or strong wind, it may be difficult for
people around you to hear the notification sound.
Also, since the vehicle approach notification device
is mounted in front of the vehicle, the rear of the
vehicle may be hard to hear compared to the front
of the vehicle. In addition, while you are driving,
you may hear a notification sound even in the car,
but it is not abnormal because it is a sound to
notify people around you to approach the vehicle.
Warning
Even if the alarm sounds, there are cases
where you do not notice the approach of
the vehicle if the ambient noise is large,
so please drive with sufficient care.