Ln4593 - LEGRAND 3440 Technical Sheet

All load dimmer RF without neutral
300W with LEDS bargraphe
Description
Actuator for the control of different loads with maximum powers 300 W, with ON/OFF
LED. For the connection of the Dimmer to the load and to the electric system no neutral
conductor is required. The selection of the ON/OFF mode based on the load to drive
(resistive or inductive) is performed using a micro-switch.
Technical data
Power supply:
Operating temperature:
Technology:
Capacity:
Power/absorption of the loads driven:
Incandescent
Voltage
lamp
Voltage
300 W
Max.
230 Vac
60 W
Min.
150 W
Max.
110 Vac
60 W
Min.
Dimensional data
Size: 2 flush mounted modules
Wiring diagram
Important:
– Connect a load before performing any "scenario" learning procedure.
– For conventional type transformers, a load with power 60% higher than their rated
power must be connected.
– For the calculation of the controllable power take into account the efficiency of
standard transformers (e.g.: transformer for a 50 W lamp with an efficiency of
0.78 => power actually absorbed by the transformer = 64 VA)
28
100 – 240 Vac 50/60 Hz
5 – 45 °C
Radio 2.4 GHz standard ZigBee®
150 m free field, 15 m in rooms with
concrete walls
see following table
Halogen Ferromagnetic Electronic
lamp transformer transformer
300 W 300 VA 300 VA
60 W 60 VA 60 VA
150 W 150 VA 150 VA
60 W 60 VA 60 VA
L
MQ00403-c-EN
Front view
8
7
6 5
8
7
6
Legend
1. + key: press and release immediately to activate the load at 66% of its power; press
and hold down to increase the power to the maximum value.
2. NETWORK LED
3. LEARNING LED
4. - key: press and release immediately to activate the load at 33% of its power; press
and hold down to decrease the power to the minimum value.
5. Load ON/OFF LED
6. ON/OFF key
7. LEARNING key
8. NETWORK key
Configuration
"Push and Learn" self-learning type.
24/09/2013
663092 H4593
0672 37

LN4593

1
2
3
4
1
2
5
3
4