Am5834 - LEGRAND 3440 Technical Sheet

IR Receiver
Description
The receiver allows you to add or replace the manual control with the remote control via
the remote controls 3527N and 3529.
The buttons on the remote control can be paired with: commands intended for actuators
with 1 relay for single loads, commands for actuators with 2 relays for double loads
(rolling shutter motor, etc.), scenario controls, and sound system and video door
entry controls. On the front of the device, in addition to the IR receiving lens, there is
a programming button and a LED to indicate reception of the IR signal sent from the
remote control and the programming phase.
Technical data
Power supply via SCS BUS:
Operating power supply with SCS BUS:
Current draw:
Operating temperature:
Size:
Configuration
If the device is installed in a My Home system it can be configured in two ways:
- PHYSICAL CONFIGURATION, inserting the configurators in position.
- Configuration via MYHOME_Suite software package, downloadable from
www.homesystems-legrandgroup.com.
Depending on the configuration of the positions A, PL1, PL2, PL3, PL4 and M it is possible
to set the IR receiver for 5 different operating modes.
Mode M
A - remote control 1 – 4
B - advanced scenarios CEN
C - self-learning remote none
D - scenario module control 6
E - sound system 9
27 Vdc
18 – 27 Vdc
8.5 mA
5 – 35°C
2 flush-mounted modules
Possible functions
repeat 4 generic controls (On/Off, Up/Down) with 4 buttons on the remote control. The required commands are saved by the receiver
during installation by inserting the configurators in positions A, PL1 - PL4 and M. Changing the preset functions requires reconfiguring
the IR receiver.
activate scenarios managed by the MH200N scenario programmer.
repeat generic controls (On/Off, Up/Down) with the buttons on the remote control. In this case the commands are saved by the
receiver with a self-learning procedure. The customer can at any time change the order and the saved commands to be called via the
remote control.
control, via the remote control, up to 16 scenarios saved in the scenario module F420.
control, via the remote control, the amplifier you want to control.
MQ00071-d-EN
573900 067216 HC4654
573901 HD4654 N4654N
8
Front view
7
PL1/PF1
PL2/PF2
PL3/PF3
PL4/PF4
6
5
Rear view
Legend
1. Receiving lens
2. Programming/reset button
3. Channel selection
4. BUS
5. Switch to enable programming
6. Operating modes
7. Control destination room number
8. LED
05/06/2014
HS4654
NT4654N

AM5834

1
2
A
3
M
4
L4654N
153