Specification Of The Digital Inputs - Siemens SINUMERIK 828D PPU Series Manual

7.7.3.4

Specification of the digital inputs

Terminal assignment for the digital inputs
Characteristics:
● X222: DI 3.0 to 3.7 are connected as rapid inputs.
● The inputs have no signaling (status LEDs).
● The inputs are not isolated.
● It is not possible to connect a 2-wire BERO.
The following figure shows an example of the terminal assignment for the digital inputs on
connector X111. Connectors X222 and X333 are assigned analogously.
①
②
Figure 7-49
Power supply for digital inputs (X111, X222, X333: Pin 2):
The internal power supply (P24OUT) is taken from the general power supply of module X1,
pin 2 (P24). Alternatively, an external power supply can be connected if the load at the digital
outputs becomes too high.
PPU
Manual, 01/2014, 6FC5397-2DP40-3BA3
When using the internal power supply P24OUT
When using the external power supply P24OUT
Terminal assignment for the digital inputs
Connectable components
7.7 PP 72/48D 2/2A PN
ext
197