Siemens SINUMERIK 828D PPU Series Manual page 140

Connectable components
7.3 MCP Interface PN
Parameter
UL certified rating
Handwheel X60 / X62
Via X60, you can connect 1 handwheel either with TTL or difference signals. Alternatively, you
can connect the handwheel via X62. You can connect only 1 handwheel to the module because
the signals from X60 are fed parallel to X62.
Use switch S2 to switch between TTL and difference signals.
Note
The handwheel is supplied by the MCP module with 5 V / 100 mA. An external power supply
is not permitted.
NOTICE
Handwheel connections
The SINUMERIK 828D software can process up to three handwheels. You can connect two
handwheels to the PPU. You can connect an additional handwheel to the machine control
panel.
Connector designation:
Connector type:
Table 7-45
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
140
X60
15-pin Sub-D socket
Assignment of connector X60
Signal name
P5V
M
HW1_A
HW1_XA
N.C.
HW1_B
HW1_XB
N.C.
P5V
N.C.
M
N.C.
N.C.
Value
Per output at 100% simultaneity of all 15 outputs: 0.15 A
Each output:
24 V / 0.15 A general, resistive load
24 V / 3.6 W lamp load
24 V / 0.15 A coil load
Type Meaning
V 5 V power supply
V Ground
I Handwheel pulses track A
I Handwheel pulses track A (negated)
- Not assigned
I Handwheel pulses track B
I Handwheel pulses track B (negated)
- Not assigned
V 5 V power supply
- Handwheel 2 pulses track A (negated)
V Ground
- Not assigned
- Not assigned
Manual, 01/2014, 6FC5397-2DP40-3BA3
PPU