Siemens SINUMERIK 828D PPU Series Manual page 96

Connectable components
7.1 MCP 483C PN
Display elements (rear)
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
⑬
⑭
Figure 7-3
LEDs for status display
When the system is booting, all three LEDs are lit.
Name Designation
H1 PowerOK
H2 PNSync
96
Ground terminal
Feed override X30
Spindle override X31
PLC I/O Interface X20/X21 connections
Slot for emergency stop
Installation locations for additional control devices (d = 16 mm)
Customer-specific inputs and outputs
Cover plate
Ethernet cable strain relief
LEDs
Switch for setting the MCP address
Switch for setting the handwheel signal type
X60 connection for handwheel, X61 reserved
Power supply interface X10
Rear panel of MCP 483C PN
Color Description
Green Lit: Power supply OK
Green Lit: System software running, STOP state
④
Detail for :
Manual, 01/2014, 6FC5397-2DP40-3BA3
PPU