Working With The Heading Sensor; Pairing The Heading Sensor - MINN KOTA i-Pilot Link Owner's Manual

HEADING SENSOR

WORKING WITH THE HEADING SENSOR

Pairing the Heading Sensor

Before the Heading Sensor can be paired, make sure that it has been properly installed and connected to a power source. Review the
LED patterns that the Heading Sensor communicates in order to understand what mode it is in and to be able to recognize that is has
successfully paired once the process is complete. To pair the Heading Sensor:
1
a. Connect the Heading Sensor to a power source.
Verify that the LED on the Heading Sensor turns on
for 3 seconds and then turns off.
b. Power on the trolling motor. Please see the trolling
motor Owner's Manual for instructions on how to
power up the trolling motor.
c. Press the Pair button on the Heading Sensor. Verify
that the LED indicates it is attempting to pair.
2
d. As quickly as possible, begin to hold the Pair button
on the i-Pilot Control Head.
e. The i-Pilot Control Head will emit a beep pattern
when the Heading Sensor is successfully paired.
Release the Pair button on the Control Head.
Watch the Heading Sensor to be sure that once it
successfully pairs that it starts emitting the LED
pattern for normal operation.
f. After the Heading Sensor is paired with i-Pilot or
i-Pilot Link, proceed to Sensor Calibration and
Sensor Offset.
NOTICE:
If battery power is lost, the Heading Sensor
will not lose its Pairing to the i-Pilot System when it is
powered down.
64 | minnkotamotors.com
2d
2e
Pair
Button
Button
LED
©2019 Johnson Outdoors Marine Electronics, Inc.
Pair