MINN KOTA i-Pilot Link Owner's Manual page 60

HEADING SENSOR
2
e. Position the sensor so that the arrow on the cover is
pointed toward the front of the boat in the direction
of travel. The arrow needs to be parallel with the keel
of the boat.
CAUTION
Failure to align the Heading Sensor correctly will result in
incorrect compass readings.
f. Mark the location of the two screw holes with an
awl or similar marking tool.
3
g. Move the Heading Sensor to the side and
drill two holes using a 9/64" drill bit on the
marked locations.
4
h. Position the Heading Sensor back in place so that
the holes drilled in the mounting location line up
with the holes in the Heading Sensor and the Power
Cable is completely threaded. Be sure to mount
the arrow towards the front of the boat and make the
alignment parallel with the keel of the boat.
CAUTION
Failure to align the Heading Sensor correctly will result in
incorrect compass readings.
If the mounting surface is thin or made of a lightweight material, the mounting surface may need to be reinforced in order to
support the Heading Sensor. Hand tighten the mounting screw to avoid over tightening and to prevent damage to the mounting
location and Heading Sensor.
60 | minnkotamotors.com
Keel of Boat
Marked
Location
of Screw
Holes
Keel of
Boat
CAUTION
Screw
Holes
Mounting Location
with Access
Parallel
Placement
Heading Sensor
Placement
Power
Cable
Screw
Holes
Mounting Location
with Access
Parallel
Placement
©2019 Johnson Outdoors Marine Electronics, Inc.
Arrow
to Front
Arrow
to Front
Power
Cable