MINN KOTA i-Pilot Link Owner's Manual page 63

5
f. Using a #2 Screwdriver, mount the Heading
Sensor to the mounting location using the two
screws. Hand tighten only.
CAUTION
If the mounting surface is thin or made of a lightweight
material, the mounting surface may need to be reinforced
in order to support the Heading Sensor. Hand tighten the
mounting screw to avoid over tightening and to prevent
damage to the mounting location and Heading Sensor.
Connecting the Heading Sensor to a Power Source
The Heading Sensor is powered by a 12-volt power source. The
Heading Sensor must be set up with a one amp fuse, either
in-line, or connected to a fuse panel. To connect the Heading
Sensor, please follow the directions below.
1. Connect positive ( + ) red lead to positive ( + ) power
source terminal.
2. Connect negative ( – ) black lead to negative ( – ) power
source terminal.
Never connect the (+) and the (-) terminals of the same battery together. Take care that no metal object can fall onto the battery and
short the terminals. This would immediately lead to a short and extreme fire danger.
©2019 Johnson Outdoors Marine Electronics, Inc.
Screw
Screw
NOTICE:
that they are high grade non-magnetic stainless steel.
To Heading
Sensor negative
(black)
WARNING
HEADING SENSOR
If replacement screws must be used, ensure
Neg - Pos +
Power Source
Fuse
To Heading
Sensor positive
(red)
minnkotamotors.com | 63