Talon Control - MINN KOTA i-Pilot Link Owner's Manual

SERVICE & MAINTENANCE

TALON CONTROL

PAIRING, CHECKING & UPDATING SOFTWARE
Pair i-Pilot Link to a Single Talon
The i-Pilot Link system is paired to the Talon using the i-Pilot Link Control Head and the Up
Indicator Panel.
1
a. Retract the anchor on the Talon by pressing the Up
button.
b. Once the Talon is fully retracted, press and hold
the Up button and the Down
simultaneously on the Indicator Panel. The Depth
Indication LEDs will begin to flash blue. Once
the LEDs are flashing, release the buttons on the
Indicator Panel.
c. The Talon will go into Pairing Mode for 20 seconds.
d. Locate the Pair Button on the top of the Control
Head. Press and hold the Pair button. A consistent
tone will be emitted from the Control Head.
e. The Control Head will scan for the Talon. Once
successfully paired, 3 longer beeps will be emitted
from the Control Head and the Talon. The LEDs
on the Indicator Panel of the Talon will also go a
sequence to confirm that the Control Head and Talon
are paired.
f. If 20 seconds pass while in Pairing Mode and they
do not successfully pair, a chirp from the Talon will
sound signaling that the Pairing has timed out.
g. If the Pair is unsuccessful, repeat the process.
Pairing i-Pilot Link with Two Talons
In order for the i-Pilot Link system to be paired to two Talons, the Talons first need to be paired together. To learn how to pair two
Talons together, read the "Pairing Two Talons and Programming the Mounting Location" section of the Talon Manual. Once the Talons
are paired together, follow the directions for "Pairing i-Pilot Link to a Single Talon". Only one Talon needs to be paired with the i-Pilot
Link system.
128 | minnkotamotors.com
1a
Up Button
button
Down Button
2e
Control Head - Ultrex,
Terrova & Riptide Terrova
and Down
Control Head - Ulterra & Riptide Ulterra
Pair Button
©2019 Johnson Outdoors Marine Electronics, Inc.
Buttons on the Talon
Indicator
Panel