Getting Started; Pairing The Device With The I-Pilot Link Controller - MINN KOTA i-Pilot Link Owner's Manual

i -PILOT LINK APP

GETTING STARTED

Pairing the Device with the i-Pilot Link Controller

In order to pair the device with the controller, the app should first
be successfully downloaded. You can check that the app was
successfully downloaded by opening it on your device. Once you
have successfully installed the app and verified installation, close
the app to begin the pairing process.
1
a. On the device you intend to pair with the i-Pilot Link
controller, turn Bluetooth "on".
b. Locate the Pair button on the top of your Control
Head. The Control Head contains the i-Pilot Link
controller. Press and hold the Pair button. The
Control Head will emit a continuous tone.
c. While the Pair button is being held down, scan for
the motor on your device. On the device, select the
motor from the list of detected devices. Once the
device is paired with the motor, the Control Head
will emit 3 longer beeps. Once you hear the beeps,
the motor was successfully paired and you can stop
pressing the Pair button.
NOTICE:
In order for the device and your motor
to stay connected, Bluetooth needs to remain "on".
Once the device is paired with the motor, they will
connect and begin communicating with each other.
d. Once the device is paired with the motor, and they
are connected, the buttons on the Home screen will
be blue. If they are not communicating, the buttons
will stay deactivated.
NOTICE:
You can have up to two devices paired to
an i-Pilot Link controller.
120 | minnkotamotors.com
NOTICE:
Your device will only be able to connect to a
motor and be paired if Bluetooth is enabled on the device
you want to pair.
1b
Control Head - Ultrex,
Terrova & Riptide
Terrova
Pair Button
Control Head - Ulterra
& Riptide Ulterra
1d
©2019 Johnson Outdoors Marine Electronics, Inc.