MINN KOTA i-Pilot Link Owner's Manual page 61

5
ITEM(S) NEEDED
#1 x 2
i. Apply a marine-grade silicone caulk or sealant to
both #8 - 18x1-1/2 screws (Item #1) as needed to
protect your boat from water damage.
j. Using a #2 Screwdriver, mount the Heading Sensor
to the mounting location using the two screws.
Hand tighten only.
NOTICE:
If replacement screws must be used, ensure
that they are high grade non-magnetic stainless steel.
Installation for No Access Under the Mounting Location
1
ITEM(S) NEEDED
a. Review the Mounting Considerations and then set
the Heading Sensor (Item #2) flat on the mounting
location and note it's placement.
b. Route the power cable through one of the two
notches in the base of the Heading Sensor. When
the arrow on the Heading Sensor is pointing towards
the front of the boat, the cable should exit the
Heading Sensor in the direction that is closest to its
intended power source.
©2019 Johnson Outdoors Marine Electronics, Inc.
#2 x 1
5i
Screw
Screw
1a Heading Sensor
Placement
HEADING SENSOR
5j
1b
Notch
Power Cable
to Battery
minnkotamotors.com | 61