MINN KOTA i-Pilot Link Owner's Manual page 58

HEADING SENSOR
The three LED patterns displayed by the Heading Sensor are:
1. Power On - When the Heading Sensor is first connected to a power source, the LED will turn on for 3 seconds and then turn off.
2. Pairing - The Heading Sensor can be paired with i-Pilot. While the Heading Sensor is attempting to pair, the LED will flash on
and off twice per second for up to 20 seconds. If the Heading Sensor is successfully paired, normal operation will begin. If the
Heading Sensor is not paired, the LED will turn off.
3. Normal Operation - During normal operation when the Heading Sensor is connected to a power source and paired to and
actively communicating with i-Pilot, the LED on the Heading Sensor will flash on and off once every 3 seconds.
INSTALLATION PARTS LIST
Item /
Part # Description
Assembly
A 2996400 HEADING SENSOR ASSEMBLY
SCREW-#8-18X1-1/2 PPH TY AB SS
1 2393400
*STAINLESS STEEL*
2 HEADING SENSOR
✖
This part is included in an assembly and cannot be ordered individually.
✖
MOUNTING CONSIDERATIONS
Before mounting your Heading Sensor, give consideration to
the following:
1. The Heading Sensor contains a compass that detects a
magnetic field. Do not install the Heading Sensor near
ferrous metals or wires that handle large currents, such
as batteries or power cables.
2. Mount the Heading Sensor in an area that has a clear line of communication with the head of the motor that is installed with a
Bluetooth compatible i-Pilot system for optimum performance.
3. Make sure the area under the mounting location is level and is clear to drill holes and installation hardware will not damage
existing components below the mounting surface.
4. Test that the Power Cable that powers the Heading Sensor is long enough to reach the power source from the intended
mounting location. If the cable does not reach the battery or intended power source, select a location closer to the source.
5. Mount the Heading Sensor horizontally. It should not be mounted upside down.
58 | minnkotamotors.com
Qty.
1
2
1
The Heading Sensor can be adversely affected by magnets or
large, ferrous metal objects. Do not install the Heading Sensor
within 24" of these objects as they will cause interference.
1
2
CAUTION
©2019 Johnson Outdoors Marine Electronics, Inc.
A