Power Up The I-Pilot Link System - MINN KOTA i-Pilot Link Owner's Manual

GETTING STARTED
2
c. If you are using an Ethernet extension cable for your
installation, connect it to the i-Pilot Link from the
Control Head. Hand tighten the Locking Collar.
NOTICE:
The connectors are keyed to prevent
reversed installation. Be careful not to force the
connectors together.
3
d. Route the i-Pilot Link Cable to the Ethernet port on
the Humminbird or to an available Ethernet port on
the Ethernet Switch.
NOTICE:
The cable should be routed through an
established routing system on the boat, in an area
with minimal interference. Inspect the selected route
carefully to ensure that there are no sharp edges,
obstacles, or obstructions that may damage the cables.
e. Hand tighten the Locking Collar.

Power up the i-Pilot Link System

Follow these simple steps each time you power up your trolling motor for successful operation:
1
a. Connect trolling motor to power.
b. Deploy trolling motor into water.
NOTICE:
i-Pilot Link startup varies slightly
between trolling motor models. The i-Pilot controller,
in the Control Head, can communicate with the
remote when the motor is stowed, once the motor
and remote have power. When the motor is stowed,
remote buttons will be disabled.
22 | minnkotamotors.com
i-Pilot Link
Cable
Locking Collar
Locking Collar
i-Pilot Link Cable
1a
Power Cables
Eight Pin
Connector
i-Pilot Link Cable from
Control Head
i-Pilot Link Cable from
Control Head
1b
Deployed
©2019 Johnson Outdoors Marine Electronics, Inc.