MINN KOTA i-Pilot Link Owner's Manual page 62

HEADING SENSOR
2
c. Double check the position of the Heading Sensor
so that the arrow on the cover is pointed toward the
front of the boat in the direction of travel. The arrow
needs to be parallel with the keel of the boat.
CAUTION
Failure to align the Heading Sensor correctly will result in
incorrect compass readings.
3
d. Mark the location of the two screw holes with an awl
or similar marking tool.
e. Move the Heading Sensor to the side and drill two
holes using a 9/64" drill bit on the marked locations.
4
ITEM(S) NEEDED
#1 x 2
f. Position the Heading Sensor back in place so that
the holes drilled in the mounting location line up
with the holes in the Heading Sensor. Be sure to
mount the arrow towards the front of the boat and make
the alignment parallel with the keel of the boat.
g. Apply a marine-grade silicone caulk or sealant to
both #8 - 18x1-1/2 screws (Item #1) as needed to
protect your boat from water damage.
CAUTION
Failure to align the Heading Sensor correctly will result in
incorrect compass readings.
62 | minnkotamotors.com
Screw
Holes
Keel of
Boat
Placement
Heading Sensor
Placement
Marked
Location
of Screw
Holes
4f
Screw
Holes
Keel of
Boat
Placement
Mounting
Location
without
Power
Access
Cable
Parallel
Mounting
Location
without
Power
Access
Cable
Parallel
©2019 Johnson Outdoors Marine Electronics, Inc.
Arrow
to Front
Arrow
to Front