System Startup; Connect I-Pilot Link To The Humminbird - MINN KOTA i-Pilot Link Owner's Manual

Battery
The Remote is powered by a rechargeable battery. By default,
the remote will automatically turn itself off after the last button
press based on the factory preset. To adjust the length of time
that the remote stays powered on, please review the "Set the
Remote Auto Off" section of this manual.
Extreme temperatures can lead to battery damage, such as capacity loss, leakage or rupture of battery. A damaged battery may
damage your remote. Avoid storing your remote in extreme temperatures. The operating temperature of your remote is -10C to 50C (14
°F to 122 °F).

SYSTEM STARTUP

Connect i-Pilot Link to the Humminbird

The i-Pilot Link can be connected directly to the Humminbird or to the Humminbird Ethernet Switch (optional). If youpurchase the
Ethernet Switch, install it using the instructions included in the Ethernet Installation Guide. The Ethernet Extension Cable is optional
for your installation. To purchase Ethernet switches, Ethernet cables, and extension cables, visit our Web site at humminbird.com or call
Humminbird Customer Service at 1-800-633-1468. Depending on the shape of the Ethernet port on your Humminbird Fish finder, an
additional ethernet adapter cable may be required for the installation. Refer to your Fish finder operations manual or see the i-Pilot Link
Compatibility Chart on our Web site at minnkotamotors.com.
1
a. Locate the Ethernet cable on the i-Pilot Link System
that exits at the Control Head.
WARNING
The power source must be turned off before you proceed
with this installation.
b. Remove the power from the motor or make sure that
the breaker, if equipped is turned "off".
NOTICE:
The appearance of your trolling motor may
vary, but the location of the i-Pilot Link Cable and
recommended routing will be the same.
©2019 Johnson Outdoors Marine Electronics, Inc.
NOTICE:
use and is especially impacted by how often and bright
the LCD backlight is used.
CAUTION
GETTING STARTED
Remote battery life is subject to frequency of
Control Head
i-Pilot Link
Cable from
Control Head
Coil Cord
minnkotamotors.com | 21