Add Ds1 Tie And Ops; Add Speech Synthesis; Add Code Calling Access - Avaya CMC1 Installation, Upgrades And Additions

Adding or Removing Hardware

Add DS1 Tie and OPS

The TN2313 DS1 Tie Trunk and TN767B (or later) DS1 Interface circuit packs
provide connections to a 1.544 Mbps DS1 facility (T1) as 24 independent
64 Kbps trunks.
The TN2313 DS1 Tie Trunk, TN767B (or later) DS1 Interface, and TN464C (or
later) DS1 Interface circuit packs provide connections to a 2.048 Mbps DS1 facility
(E1) as 32 independent 64-kbps trunks.
Service Interruption
1. Since the addition of DS1 tie-trunk service may require a service
interruption, notify the customer in advance as to when the addition will
occur.
2. For information about administering DS1 Tie Trunks, refer to
Administrator's Guide for Avaya MultiVantage Software.

Add Speech Synthesis

The Speech Synthesizer circuit pack is required when the Voice Message
Retrieval, Automatic Wakeup, or Do Not Disturb features are activated. The circuit
pack does not require administration.
1. Determine the port assignment of the Speech Synthesizer circuit pack
being added.
2. Install the Speech Synthesizer circuit pack in the designated carrier slot.

Add Code Calling Access

The tones for the Code Calling feature are generated by the Tone-Clock circuit
packs in the port networks.
1. Install an Auxiliary Trunk circuit pack or a Speech Synthesizer circuit pack
and connect for Loudspeaker Paging. The Code Calling Access feature
shares the same ports as Loudspeaker Paging. An Auxiliary Trunk circuit
pack provides 4 ports for Loudspeaker Paging and Code Calling Access.
2. Administer the form listed under "Code Calling Access" in Administrator's
Guide for Avaya MultiVantage Software.
5-30
Issue 5 October 2002 555-233-118