Saving The Configuration - ADC 600F User Manual

Configuring the LAN
Information
DHCP
Enable
Lease IP Address Range
Primary DNS
Secondary DNS
Default Gateway
2 Enter the IP address
3 Click on the box adjacent to the letters DHCP. A check mark in the box indicates the
modem's DHCP server is enabled. No check mark in the box indicates the modem's DHCP
server is not enabled.
4 Click Apply .

Saving the Configuration

Although you have submitted your new system settings, the parameters are not permanent
until you write them to NVRAM. See
to save to NVRAM.
70
Description
Dynamic Host Configuration Protocol. Used to assign dynamic IP addresses.
Enables/Disables the modem's DHCP server.
Range of IP addresses to lease out. The starting address is one address higher
than the LAN IP address. The pool size is 256.
IP address of the primary Domain Name Service (DNS) device that translates
names into IP addresses.
IP address of the secondary Domain Name Service (DNS) device that translates
names into IP addresses.
Default router set to the IP address of the LAN port.
and the Net Mask .
"Saving the Configuration" on page 28
Megabit Modem 400F, 500L, 600F, and 700F User Manual
when you want