ADC 600F User Manual page 51

Information
Private IP Address
Private Port
Proxy IP Address
Proxy Port
Remote IP Address
Remote Port
Protocol
2 Enter the Private IP Address
3 Enter the Private Port number
4 Enter the Proxy IP Address
5 Enter the Proxy Port number
6 Enter the Remote IP Address
do not have the information for the remote user, enter 0.0.0.0.
7 Enter the Remote Port number
example, specify 23 for telnet traffic and specify 21 for FTP traffic. If you do not have the
information for the remote user, enter 0.
8 Select the Protocol
9 Click OK to accept the changes or
Megabit Modem 400F, 500L, 600F, and 700F User Manual
Description
The non-registered IP address of a device on the LAN side of your modem.
The logical port number where TCP or UDP traffic will be sent to from the WAN
after it is translated from the Proxy Address/Port combination.
The registered (public) IP address mapped to the Private IP Address. Permitted
traffic sent to this address from the WAN will end up at the device with the
associated Private IP Address. This is the IP address assigned to the WAN port
by the service provider.
The logical port number that TCP or UDP traffic will first be sent to from the WAN.
The IP address of the device across the WAN that will be sending the TCP or UDP
traffic to your local device with the Private IP Address. Set this to 0.0.0.0 to allow
access by any host.
The logical port number of the remote device that will be sending the UDP or TCP
traffic. For example, specify 23 for telnet traffic and specify 21 for FTP traffic. This
is usually set to 0 to allow any port.
The protocol, UDP or TCP, to be used as the transport between the LAN and the
remote user for this static NAT entry.
of the device on the LAN side of the modem.
of the device on the LAN side of the modem.
that is mapped to the Private IP Address.
that is mapped to the Private Port.
of the device across the WAN that will initiate a session. If you
of the device across the WAN that will initiate a session. For
from the drop-down menu.
Cancel
Chapter 5: Configuring System Settings
to return to the previous screen without changes.
41