Saving The Configuration And Effecting Changes - ADC 410F User Manual

Saving the Configuration and Effecting Changes

S
AVING THE
E
FFECTING
As you make changes to the modem configuration, click the
accept changes and write the changes to RAM. After you make all the necessary changes, you
must save them to Non-Volatile RAM (NVRAM). The following LAN-WAN configuration
changes are not permanent until you write them to NVRAM and will not take affect until the
modem is reset:
•
for both LAN and WAN:
– IP address and IP net mask (subnet IP mask)
– RIP version (see
• when DHCP is enabled
– DHCP start IP address (which the modem automatically sets)
–
primary DNS IP address
– secondary DNS IP address
See the following sections to:
•
save configuration changes to NVRAM on
• reset the modem to activate the configuration on
•
reset the modem to restore the factory default values on
When you click the
changes are automatically written to NVRAM. You must reset the ADSL link to effect these
changes.
See the following sections to:
• reset the ADSL link to activate the ADSL configuration on
•
reset the modem to restore the factory default values on
36
C
ONFIGURATION AND
C
HANGES
page 50)
(page 50):
Submit button on the Web page to accept ADSL configuration changes, the
button on the Web page to
Submit
(page 49)
page 37
page 38
page 39
page 54
page 39
Megabit Modem 410F and 420F User Manual