Table of Contents
Advertisement
Assigning LAN Users to PPP Sessions
A
SSIGNING
Map the IP addresses for the LAN-side users to each PPP over ATM session.
In PPP over ATM mode, you can map up to a maximum of 8 users to the
sessions you configure for the 500L. In addition, you can map 64 users to the
sessions you configure for the 600F and 700F. For example, you could map two
users to 32 configured sessions, 64 users to one configured session, or any
combination you choose, up to a maximum of 64 users mapped to all the
sessions you configure. You can map multiple users to one session; you
cannot, however, map multiple sessions to any user.
Enter the IP address or addresses for each user on the LAN that will be assigned to this session.
To access, select
Information
Connection Name
User's IP Address
Inbound NAT Default
Add a User Assignment
1
From the
wan
2
Click
Add
to display the user assignment Entry window.
3
Configure the user assignment parameters defined in the table above.
4
Click
Apply
to add the new data to the list. To cancel the process, click
60
LAN U
SERS TO
User Assignment
on the
Description
The name of the PPP session.
The IP address of the LAN-side user's machine.
The default device for inbound traffic. This parameter should be configured when
setting up the WAN PPP session. See
page 53
for more information.
menu, click
user assignment
PPP S
PPP over ATM WAN Configuration
"Configuring the WAN PPP Sessions" on
to open the WAN User Assignment window.
Megabit Modem 400F, 500L, 600F, and 700F User Manual
ESSIONS
page.
Cancel
.
Advertisement
Table of Contents
Troubleshooting
