Setting Up Adsl Service; Checking Led Indications - ADC 600F User Manual

Setting Up ADSL Service

S U
ETTING P
The service provider sets up the ADSL parameters for your service. The modem must have
the ADSL SYNC LED lit before you can connect sessions with your service provider. Verify
SYNC in the following section,
C LED I
HECKING
The table below describes LED indications for all operational modes. LEDs on the modem front
panel provide continual status at-a-glance for network and modem connections.
LED State
PWR On green
Off
LINK On green
Off
TX Flashing green
Off
RX Flashing green
Off
SYNC On green
Flashing green
Off
TX Flashing green
Off
RX Flashing green
Off
MAR On green
Off
OH On yellow
Off
20
ADSL S
ERVICE

"Checking LED Indications."

NDICATIONS
Description
Modem has power.
Modem does not have power.
A PC, hub, or other network device is connected to the modem
10/100BASE-T interface.
No device is connected to the modem 10/100BASE-T interface.
Modem is transmitting data to devices on the LAN.
Modem is not transmitting data to the LAN.
Modem is receiving data from devices on the LAN.
Modem is not receiving data from the LAN.
ADSL transceiver is synchronized and in normal operation mode.
ADSL transceiver is in a start-up sequence.
ADSL modem transceiver is not detecting a transceiver at the far end.
Modem is transmitting data to the service provider.
Modem is not transmitting data to the service provider.
Modem is receiving data from the service provider.
Modem is not receiving data from the service provider.
ADSL margin is at or above the value set by the service provider.
ADSL margin is below the value set by the service provider.
Telephone receiver is off hook.
Telephone receiver is on hook.
LAN
ADSL
Megabit Modem 400F, 500L, 600F, and 700F User Manual