Symbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch BAT 690 Repair Instructions

en 20 | BAT 690 | Symbols used
1.

Symbols used

1.1

In the documentation

1.1.1 Warning notices -
Structure and meaning
Warning notices warn of dangers to the user or
people in the vicinity. Warning notices also indicate
the consequences of the hazard as well as preventive
action. Warning notices have the following structure:
KEY WORD – Nature and source of hazard!
Warning
symbol
Consequences of hazard in the event of
failure to observe action and information
given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence
and the severity of the hazard in the event of non-
observance:
Key word Probability of
occurrence
DANGER Immediate impending
danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
1.1.2

Symbols in this documentation

Symbol Designation Explanation
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps.
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible

result intermediate result.
Final result There is a visible final result on
"
completion of the instruction.
1.2

On the product

!
Observe all warning notices on products and ensure
they remain legible.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
|
1 689 975 288 2017-06-30
Severity of danger if
instructions not observed
Death or severe injury
Death or severe injury
Minor injury
2.

User instructions

2.1

Target group

Installation and/or repair work is only to be
performed by qualified and trained customer service
personnel from Robert Bosch GmbH or organizations
commissioned by Robert Bosch GmbH. No warranty
claims will be accepted if devices have been opened or
modified by non-authorized persons.
Electrical systems and equipment are only to be started
up if they are in proper working order (see also to test
system information 0108_084). This requirement is
deemed to have been fulfilled if compliance with the
rules of electrical engineering practice is ensured on
completion of modification or repair work (initial test).
This requires the performance of tests of the type and
scope specified in the measures defined in electrical
engineering rules (e.g. in Germany, DGUV V3). In
Germany, the nature and extent of testing are specified
in VDE 0701/0702 Part 1. The corresponding legislation
of the country concerned must be observed.
2.2

Equipment required

R
Standard tool for electricians
R
PC/laptop with Win 7 or higher for software updates
R
USB connecting cable for connection BAT 690 to
PC/laptop
R
Circuit board M1 (HMI)
R
BAT 6XX - Update tool
2.3

ESD protection

!
Note the ESD handling instructions in EDIS and
remove components with care.
Robert Bosch GmbH