Testing the Memory Modules Installation
Testing the Memory Modules Installation
This section describes how to test the memory modules and
Summary
verify that they work correctly.
Important
Information
Testing the
After you have completed installing the memory modules,
Memory
you must test the connections. Enter the command shown
in Example 12–1 to display the memory configuration. If the
resulting display does not show the correct memory size or
configuration, enter the command shown in Example 12–2 to
test the memory modules. If the resulting display contains
question marks and error messages, check the memory module
connections again. If the memory modules are installed correctly,
contact your Digital service representative.
12–10 Installing and Removing Memory and the NVR Battery
Reassemble the system following the procedures listed in
Chapter 9 before you turn on the system unit.
Caution