Replacing A 3.5-Inch Diskette Drive - Digital Equipment DECpc AXP 150 Customer Technical Information

Replacing a 3.5-Inch Diskette Drive

Replacing a 3.5-Inch Diskette Drive
This section describes how to replace a 3.5-inch diskette drive in
Summary
the front drive bay.
3.5-Inch Table 11–7 lists the steps that you must follow to replace a
Diskette Drive 3.5-inch diskette drive in the front drive bay.
Replacement
Procedure
Table 11–7 Replacing a 3.5-Inch Diskette Drive
Step
1
2
3
4
5
6
7
8
11–14 Installing or Removing Internal Storage Devices
Action
Remove the drive that is just below the 3.5-inch
diskette drive.
Remove the original 3.5-inch diskette drive.
Set the ID select switch on the replacement diskette
drive to the same position as the ID select switch on
the original diskette drive.
Attach the mounting bracket ( ) to the replacement
3.5-inch diskette drive using the four screws ( ) that
you removed from the original diskette drive.
Insert the mounting bracket and diskette assembly
into the system unit, and pull it forward to secure the
three mounting bracket clips in the appropriate slots
on the chassis.
Secure the assembly to the system unit box using the
retaining screw ( ).
Connect the power cable ( ) and the data cable ( ) to
the diskette drive.
If necessary, replace the drive you removed from below
the diskette drive.