Installing Or Replacing Memory Modules - Digital Equipment DECpc AXP 150 Customer Technical Information

Installing or Replacing Memory
Installing or Replacing Memory
This section describes the following tasks:
Summary
•
•
•
Memory Module Table 12–3 lists the steps that you must follow to install or
Installation or replace memory modules.
Replacement
Procedure
Table 12–3 Installing or Replacing Memory Modules
Step
1
2
3
4
12–8 Installing and Removing Memory and the NVR Battery
Installation of a second memory option in a system
configured with only one memory bank occupied
Replacement of a 16M-byte memory option in a memory
bank with a 64M-byte memory option or vice versa
Replacement of one or more faulty memory modules
You may need to remove other memory modules to access
particular memory modules or memory connectors. You
must replace these other modules in the locations from
which you removed them.
Action
Read the section entitled Handling and Configuring
Memory Options before you continue.
Remove the appropriate memory modules by holding
back the metal clips on the memory module connector,
tilting the memory module, and lifting it out of its
connector.
Install a new memory module if the one you removed
is faulty or if you are upgrading a memory bank.
Reinstall the memory modules you removed for access
purposes.
Note