Configuring The System Diskette Drives - Digital Equipment DECpc AXP 150 Customer Technical Information

Configuring the System Diskette Drives
Configuring the System Diskette Drives
This section describes how to configure the system diskette
Summary
drives.
Configuring Table 2–14 lists the steps that you must follow to configure the
system diskette drives.
the System
Diskette Drives
Table 2–14 Configuring the System Diskette Drives
Step Action
1 If necessary access the Setup menu.
2 Choose the
Set default
menu item and
configuration
press Enter.
3 Choose the diskette drive capacity
and press Enter.
4 If the system does not contain a
second diskette drive, choose no
and press Enter.
5 If the system contains a second
diskette drive, choose yes and press
Enter.
6 Choose the diskette drive capacity
and press Enter.
7 If you have finished making
changes in the Setup menu, see
the section entitled Saving the
System Set-Up or Quitting the
Setup Menu .
2–22 Using the Windows NT Firmware
Result
The system displays the Setup menu.
The system displays a prompt asking you
to choose the diskette drive capacity.
The firmware holds a value indicating the
diskette drive capacity in memory. It then
displays a prompt asking you to specify
whether there is a second diskette drive.
The firmware holds the value N in
memory, then displays the Setup menu.
The system displays a prompt asking you
to choose the diskette drive capacity.
The system holds a value indicating the
diskette drive capacity in memory, then
displays the Setup menu.
The system saves the changes only when
you exit from the Setup menu.