Removing The Front Peripheral Bay Bezel - Digital Equipment DECpc AXP 150 Customer Technical Information

Removing the Front Peripheral Bay Bezel

Removing the Front Peripheral Bay Bezel
This section describes how to remove the front peripheral bay
Summary
bezel. You must remove this bezel before you can remove either
the RX26 3.5-inch diskette drive or any removable media devices
or disk drives in the front 5.25-inch drive bays.
Important
Information
Front Table 11–3 lists the steps that you must follow to remove the
Peripheral Bay front peripheral bay bezel.
Bezel Removal
Table 11–3 Removing the Front Peripheral Bay Bezel
Step
1
2
3
11–6 Installing or Removing Internal Storage Devices
You must remove the system unit covers to complete
most of the following procedures. See Chapter 9 for
information on removing the system unit covers.
Action
Remove the system unit covers following the procedure
in Chapter 9.
Pull the bezel locking-latch ( ) out until it stops.
Lift the front peripheral bay bezel from the bottom and
then lift it out and off its hinges ( ).
Note