Downloading The Cnc Configuration Data - Bosch Rexroth IndraMotion MTX micro Commissioning Manual

DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
5.4

Downloading the CNC Configuration Data

4. Turn the PC and the MTX micro off and on again.
After communication has been successfully established, the CNC parameters
of the basic project must be downloaded to the MTX micro. To do this, extract
these parameters from an archive ("TAR File") which is an integral part of the
basic project. Proceed as shown in the figure below.
1. Select the "IndraMotion_MTX_micro_c" node. Right-click on this node and
select "Restore..." and "Control Data..." from the context menu.
2. Select the archive to be downloaded by clicking on the button to the right
of the input field.
3. The archives are filed in the default project in the >Project Directory>\TAR
directory.
4. Activate all restore checkboxes and confirm with "Next>>".
5. Activate all checkboxes and confirm with "Next>>".
6. Check your entries and start restoration by clicking on "Finish".
7. Restoration comprises 3 phases, and the control repeatedly restarts ac‐
cordingly.
8. This dialog shows the successful restoration of the CNC configuration da‐
ta.
After the NC parameters have been restored, the MTX micro must
be turned off and on again twice. This initializes the parameters of
the NC and the connected drives.
Bosch Rexroth AG
Software Installation and Basic Projects
57/141