Errors In Communication With The Mtx Micro - Bosch Rexroth IndraMotion MTX micro Commissioning Manual

56/141 Bosch Rexroth AG
Software Installation and Basic Projects
5.3.6

Errors in Communication with the MTX micro

Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
4. After having switched communication to online, the "NC configuration" and
"NC file system" nodes are activated.
Fig.5-8: Switching communication with the MTX micro to online
If communication with the MTX micro is disturbed on switching to online mode,
the following dialog will be displayed:
Fig.5-9: Communication error
Possible remedies:
1. Check whether the Ethernet cable is properly connected.
2. Use an Ethernet crossover cable if your PC does not support the "Auto‐
sensing" function.
3. Check the settings of the IP addresses of the PC and the MTX micro once
more.
DOK-MTXMIC-EASY*******-CO04-EN-P