Assigning The Axes To The Drives - Bosch Rexroth IndraMotion MTX micro Commissioning Manual

DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
7.3.2

Assigning the Axes to the Drives

The system axes are assigned to the drives of the HCQ02 and HCT02 drive
controllers by assigning the SERCOS address in the NC configuration. The
SERCOS addresses are permanently assigned to the drives. The assignments
are shown in the following figure.
Fig.7-11: Relation between drive, connection and SERCOS address
The following axis configurations are defined in the basic projects:
Fig.7-12: Axis configurations of default projects
Bosch Rexroth AG 83/141
NC Parameterization