Nc Parameterization; Introduction - Bosch Rexroth IndraMotion MTX micro Commissioning Manual

DOK-MTXMIC-EASY*******-CO04-EN-P
Rexroth IndraMotion MTX micro Easy setup for Standard Turning and Milling Machines
7

NC Parameterization

7.1

Introduction

This chapter describes how to parameterize the NC. It is assumed that the NC
parameters have already been downloaded correctly (TAR file, see chapter
1.4).
If the appropriate IndraWorks basic project was used, most of the NC param‐
eters are already preset correctly. The only adjustments that must still be made
refer to velocities, travel ranges, etc.
We nevertheless recommend that you check and, if necessary, ad‐
just the NC parameters mentioned in this chapter.
Bosch Rexroth AG 75/141
NC Parameterization