Fujitsu FLM 150 ADM Maintenance And Trouble Clearing page 191

Maintenance and Trouble Clearing
FJTU-320-515-480
Step 5 If any of the facilities in the applicable group are in service, place them out of
service.
a. From the Provisioning menu, choose Service State, then choose Change
Facility State.
b. Click the applicable units, then click on any nonselectable unit. A dialog box
opens.
c. Select the appropriate Channel IDs. If low-speed units were selected, the
dialog box shows Channel IDs. If high-speed units were selected, the dialog
box does not show Channel IDs.
d. Select OOS Memory Admin.
e. Click OK.
f. Click Close or Cancel.
Step 6 Place the equipment slots for the group out of service.
a. From the Provisioning menu, choose Service State, then choose Change
Equipment State.
b. Click the applicable units, then click on any nonselectable unit. A dialog box
opens.
c. Select Out of Service (MA).
d. Click OK.
Step 7 Change the Group Configuration.
a. From the Provisioning menu, choose System then choose Set Group
Configuration. The system dialog box opens.
b. Select Group Configuration.
c. Select the appropriate facility type for the group being modified.
Issue 9, May 1999 FNC and FNC Customer Use Only
5.8: Correcting a Mismounted Unit
Vol. ll, Page 480.5-29