Correcting A Mismounted Unit - Fujitsu FLM 150 ADM Maintenance And Trouble Clearing

Maintenance and Trouble Clearing
FJTU-320-515-480
5.8

Correcting a Mismounted Unit

5.8.1 Overview
A mismounted unit is indicated by a blinking red FAIL LED that denotes either of
the following troubles:
• The slot is configured for a different type of unit.
• The mounted unit is not used in this configuration.
No alarm is generated by a mismounted unit.
To correct a mismounted unit, use the appropriate procedure presented below:
FLEXR or TL1.
5.8.2 FLEXR Procedure
Should the unit have been installed in another slot?
Step 1
Move the unit to the correct slot.
You have completed this procedure.
Step 2 Should a different unit have been installed in the slot?
Replace the incorrect unit with a correct unit.
You have completed this procedure.
Issue 9, May 1999
If Yes:
If Yes:
FNC and FNC Customer Use Only
5.8: Correcting a Mismounted Unit
If No:
Go to Step 2.
If No:
Go to Step 3 to retrieve
the current provisioning.
Vol. ll, Page 480.5-27