Fujitsu FLM 150 ADM Maintenance And Trouble Clearing page 17

Maintenance and Trouble Clearing
FJTU-320-515-480
1.2.3 Report Formats
Alarm Report Format
Report alarm (REPT ALM) messages are generated by the system to report the
occurrence of an alarm event. Each event causes a separate message. The only
conditions that appear in a REPT ALM message are those with provisioned
notification codes of CR, MJ, or MN. (Note that housekeeping [environmental]
alarm reports use a different format, which is shown in the next section.)
The format for an autonomous alarm report (real time) or an alarm report
retrieved at a later time using RTRV-AO and an example follow.
TID DATE TIME
ALMCDE ATAG REPT ALM AIDTYPE
"AID:NTFCNCDE,CONDTYPE,
SRVEFF,,,LOCN,DIRN,,,:\"COND DESCR\""
Example:
The RTRV-AO command retrieves an alarm from the AO buffer, which will
indicate the time at which it was generated. If the operator wants to know if the
condition still exists, the RTRV-ALM-ALL or RTRV-COND-ALL command can be
used, which will result in a real-time report.
The format for a report retrieved using RTRV-ALM-ALL or RTRV-COND-ALL
and an example follow.
"AID,AIDTYPE:NTFCNCDE,CONDTYPE,SRVEFF,,,LOCN,DIRN,:\"CONDDE
SCR\""
Example:
"Unit is removed\""
Issue 9, May 1999
FUJITSU 95-12-23 20:43:44
*C 000003 REPT ALM EQPT
"TS1A-W:CR,RMVD,SA,,,NEND,NA,,,:
\"Unit is removed\""
MC1A-4-W
" ,EQPT:CR,RMVD,SA,,,NEND,NA,:\
FNC and FNC Customer Use Only
1.2: Message Parameter Interpretation
Vol. ll, Page 480.1-7