Correcting The T1 Or T3 Framing Format - Fujitsu FLM 150 ADM Maintenance And Trouble Clearing

Maintenance and Trouble Clearing
FJTU-320-515-480
5.5

Correcting the T1 or T3 Framing Format

5.5.1 Overview
This procedure describes the retrieval and editing of the provisioning to verify
that the T1 or T3 framing format matches the signal format. Note that the
engineering work order provides the appropriate provisioning.
This task can be performed using any of the following procedures presented
below: FLEXR or TL1.
5.5.2 FLEXR Procedure
Retrieve the T1 or T3 format.
Step 1
a. From the Provisioning menu, choose Facility, then choose Set Facility.
b. Click the unit, then click the shelf edge. A dialog box opens.
c. Click Retrieve to show the current format setting. The possible settings are
shown in the following table.
(Only if Group is configured for D1E)
UNFR (unframed)
SF (superframe)
ESF (extended superframe)
DLC16
Is the facility provisioned correctly?
Click Close.
Call the Fujitsu Technical Assistance Center at
1-800-USE-FTAC (1-800-873-3822) for assistance.
Issue 9, May 1999
5.5: Correcting the T1 or T3 Framing Format
T1
If Yes:
FNC and FNC Customer Use Only
T3
ASYNC (asynchronous)
UNFR (unframed)
—
—
If No:
Go to Step 2.
Vol. ll, Page 480.5-17