Expanding and assigning parameters to the device
6.3 Expansion cards
6.3.6
Installing and configuring the hardware RAID adapter card
This section describes how you install and configure a RAID adapter card, based on the
example of ASR-8405. The description applies equally to other permissible RAID adapter
cards.
Requirement
For installation of the hardware RAID adapter card, you require the following:
● Tx10 screwdriver
● The hardware RAID adapter card with connection for the SAS/SATA data cable
connection for the capacitor block of the ZMM
● An adapter cable for connection of the hard disk drive
Observe the numbering of the connections
78
②
①
to the RAID module
②
.
Operating Instructions, 07/2019, A5E45118479-AB
①
and
SIMATIC IPC1047