Mounting The Device; Installation Guidelines - Siemens SIMATIC IPC1047 Operating Instructions Manual

3.2

Mounting the device

3.2.1

Installation guidelines

Dangerous voltage and fire hazard
Improper actions during installation and assembly may lead to personal injury and/or
damage to equipment.
You should observe the installation and assembly notes under:
• General safety instructions (Page 21)
• Notes on ambient and environmental conditions (Page 26)
A high voltage may be present in the switchgear cabinet and could cause a dangerous
electric shock.
It may result in death or serious physical injury.
Isolate the power supply to the switchgear cabinet before opening it. Ensure that the power
to the control cabinet cannot be turned on accidentally.
Life-threatening voltages when control cabinet is open
When you open the control cabinet, there may be a dangerous voltage at certain areas or
components.
Touching these areas or components can cause death or serious physical injury.
• Always disconnect the cabinet from the mains before opening it.
• Ensure that the power to the control cabinet cannot be turned on accidentally.
Risk of physical injury
The device is too heavy to be mounted exclusively with the 19" brackets of the front panel.
The device may fall down, injure people and get damaged.
• Secure the device additionally using cabinet brackets, telescopic rails or a device base.
• Use the brackets on the front panel to carry and lift the unit.
SIMATIC IPC1047
Operating Instructions, 07/2019, A5E45118479-AB
WARNING
WARNING
CAUTION
The mounting screws of the telescopic rails may not protrude more than 5 mm into the
device.
Installing and connecting the device
3.2 Mounting the device
31